Wooden door installation master

If the wooden door installer recruits, he can go to the same city to recruit and so on. If you make money, it depends on how much you do Well, there are four doors a day on average, about one hundred. I've taken 14 thousand at most, and I'm tired

Installation mode of wooden door. 1. When assembling the door cover, first find out the door cover and the riser, and align the joints according to the number on the back, and the joints should be on the same plane. Apply glue to the joint, put 25mm wood screw on the guide hole on the back of the joint and tighten it with a screwdriver. Do not screw the screws directly into the door cover. Check whether the size between the joints is correct, whether the joints are smooth, dense and firm, and then install the iron pieces on the back of the door cover riser.

2. Install the door cover. Put the firmly assembled door cover into the doorway, and fix the door cover around with small wooden blocks. Both sides of the door cover should be on the same plane as the wall. Then check whether the door cover is vertical to the ground, whether the two corners of the top plate of the door cover are at right angles to the two vertical plates, whether the vertical plates of the door cover are bent, and wind the iron plates at both ends on the wall. According to the position of the reserved hole on the iron sheet, drill 8mm holes in the wall with an electric hammer, plug them with small battens, then fix the iron sheet on the wall with 80mm wooden screws, and then fill the gap between the door cover and the wall with small battens, re-check whether the door cover and the door are consistent, and then drive in styrofoam.

3. When installing the door leaf, open the hinge slot first. The distance between the hinge slot and both ends of the door leaf should be110 of the height of the door leaf. For heavier doors, three hinges should be installed, and the depth of hinge groove should be the single thickness of hinge. When installing the hinge, use screws matching the hinge, and tighten the screws with a screwdriver. It is not allowed to directly knock in the screws with a hammer. After the hinge on the door leaf is fixed,