How to change the vertical shaft oil seal of the rear wheel of Weikang 3.2 ton forklift?

The steps of replacing the vertical shaft oil seal of the rear wheel of Wellcome 3.2-ton forklift are as follows:

1. Lift the forklift and support it firmly at the same time, so as to replace the oil seal.

2. Use a wrench or screwdriver to remove the rear wheel of the forklift. Pay attention to mark the tire position before disassembly, so that it can be installed correctly when replacing the rear wheel.

3. Remove the shaft, and remove the vertical shaft oil seal with the oil seal remover, taking care not to damage the bearing and bearing seat.

4, clean the surface of the axle and bearing seat, in order to replace the new oil seal installed firmly.

5. Install the new vertical shaft oil seal, and install it on the bearing seat with the oil seal installation tool, paying attention to the installation direction and depth.

6. Install the axle and tire, and tighten the screws with a wrench or screwdriver.

7, check whether the installation is firm, use manual lifting forklift, observe whether the tire can rotate freely, whether there are abnormal conditions such as abnormal sound.