Mainly cedar board, the thickness is more than 100 square meter. Pile the wood in a small room, put an iron drum on the briquette stove and add water. Can you dry the wood?

Wood drying equipment drying equipment can dry all kinds of trees, specifications and uses. It has the advantages of high efficiency and energy saving, safety and reliability, short drying cycle, good drying quality and low drying cost. Widely used in large, medium and small wood processing enterprises, especially those engaged in wood products export business. When the wood drying equipment is in normal operation, the fuel is fully burned in the combustion chamber to generate heat energy, which is fully absorbed by the drying medium in the heat energy drying system to generate a temperature of about 170 degrees Celsius. Under the action of the circulating fan, the high-temperature airflow passes through the control system and the conveying system to convey the high-temperature hot air to the drying room to dry the wood. At the same time, the steam generator on the equipment can generate a large amount of atmospheric steam, which can be sent to the drying room at the right time according to the requirements of the drying process to spray and humidify the wood. Humidity control system is an independent steam system with safety devices. Saturated wet steam can make the surface humidity and internal humidity of wood tend to be consistent in a short time, thus achieving the purpose of drying wood inside and outside. For solid, hard and thick wood, intermittent heating and drying process can be used to solve the defects such as internal crack, end crack and deformation during wood drying, and greatly improve the timber yield. Wood drying equipment is equipped with heat energy recovery system, which can make full use of drying medium and overcome the heat loss caused by the discharge of hot and humid air to the maximum extent. The recycling of heat energy greatly reduces the drying cost and shortens the drying cycle. When the moisture content of wood falls below 15%, after 6-8 hours of high-temperature dry steaming, all moths and eggs parasitic in wood can be killed, which solves the adverse effects caused by moths and improves the economic benefits for enterprises. The air inlet and air return pipelines of the equipment are equipped with adjustable valves, which can adjust the air inlet and rotary air volume at any time according to the requirements of wood drying process. The air inlet of the fan also has an adjustable compensation, which can adjust the wind pressure and air volume in the drying room accordingly. The main body of the equipment is equipped with a steam injection regulating valve to adjust the steam injection quantity in time according to the different needs of wood drying. The lower part of the equipment main body is also provided with a combustion-supporting device. When the fuel is not easy to burn for various reasons, the combustion-supporting valve can be opened to increase the combustion intensity and reach the required temperature in each drying stage. Users can flexibly design the drying chamber size according to their own drying requirements, ranging from 10 cubic meter to 150 cubic meter. (If the drying capacity exceeds150m3 at a time, it is recommended to use a steam drying kiln, and the kiln bodies above150m3 in our factory are all controlled. Look at another introduction, the price guarantee is the lowest. ). It can be designed into semi-automatic operation (automatic dehumidification and automatic humidification) according to your company's requirements, which is the best choice for small and medium-sized enterprises. The system includes air inlet pipeline, air return pipeline, main fan, dehumidification system, hot blast stove and control instrument (including wet and dry bulb instrument).