Which department should I look for for approval for house decoration?

Housing decoration needs the approval of the planning department, and the operation process is as follows:

1. Planning and construction procedures are required. Before house decoration, an application must be filled in and approved by the planning department. After the approval is completed, you can go through the decoration procedures. Housing construction can participate in decoration, can start construction, and can go through the formalities of real estate registration and change after completion.

2. Safety approval application. The owner must apply for renovation before renovation, and the real estate administrative department shall decide whether to approve the renovation notice within 20 working days.

3. Obtain a building certificate. The applicant for house decoration shall go through the construction application procedures with the approval letter to the construction administrative department and obtain the construction permit.

What are the steps of room renovation?

1. Find the structural layout of the original house. In other words, we should at least find the original picture and then determine each type. For example, we can find the original structural drawing or the original architectural drawing, so that we can confirm the specific structure of each location, which is convenient for us to re-plan.

2. Use the original structure to arrange the new layout. Because the wall to be added behind us, if it is a masonry wall, must have a load-bearing beam below it, otherwise it may lead to cracks in the floor. So at this time, it is necessary to find the load-bearing structure of the floor to arrange the wall.

3. We can also use light partition walls to partition the floor. For example, our most commonly used light steel keel gypsum board wall is used as a partition, which can increase the wall and will not affect the stress of the floor.

4. Draw a new layout. That is to say, when we confirm that all the added rooms have changed the original layout, we should draw a new layout first. This also includes the layout and width of the walls in our indoor rooms. So as to confirm the new layout.

5, elastic line as a partition. After we draw the new layout, we can start work. At this time, we can pop up corresponding ink lines on the ground, that is, the control lines of the wall, and finally carry out construction according to these lines. After this transformation is completed, it is the new layout we need.