Wiring diagram of five-hole switch socket, how to wire the five-hole switch?

First, I'll show you the next five-hole switch socket. There are two kinds of five-hole switch sockets: one-hole single control and one-hole double control. Today I will explain the wiring diagram of these two switches.

Wiring diagram of one-opening five-hole switch control bulb

For the switch belt socket, its interior has been connected, and we only need to align it to connect it externally. This is a single control switch for a five-hole socket. The switch and socket do not affect each other. The switch controls the connection line of the light bulb to the L position of the five-hole socket switch, and the L 1 socket and the zero line are simultaneously linked to the light bulb. This completes the wiring of the switch. Next, connect the socket part. Similarly, the live wire is connected to the L neutral line, and the ground wire is connected to the N grounding mark. Here, the L of the switch can be directly connected to the L of the socket, which can save the wiring cost. At this point, the wiring is complete.

Remarks: The "L" of the field switch in the schematic diagram corresponds to the "com" in other products, which is a similar interface.

Wiring diagram of one-opening five-hole switch control socket

Switches with sockets can also be used to control the power supply of sockets. The wiring is as follows: the live wire enters the switch L, then the L 1 socket is connected to the socket L, and the zero wire is connected to the N ground wire in the middle, thus completing the wiring method of a five-hole switch control socket!

Remarks: The "L" of the field switch in the schematic diagram corresponds to the "com" in other products, which is a similar interface.

Wiring diagram of a five-hole double-control switch with one opening.

Open five holes at a time, not only with single control switch, but also with double control switch. This paper introduces a five-hole double-control switch, two switches control a three-switch lamp. This method can be used for the layout of bedroom switch sockets. There are two single-connected and double-controlled sockets with two or three poles on both sides of the bedside table, and a multi-control switch is installed at the door. Compared with the distribution of switch sockets on both sides of the bedside table, it will save some costs, and its specific wiring mode can be connected as shown in the figure. It should be noted here that the incoming line must be connected from one opening to five holes and then separately!

Remarks: The Xiye switch "l, L 1, L2" in the schematic diagram corresponds to "com, com 1, com2" in other products, which is a similar interface.