Why use LED lights for underground garage lighting?

1. Lighting condition of underground garage:

The energy consumption of underground garage lighting is the biggest headache for property management companies. 24-hour lighting should ensure the brightness of lighting and the driving safety and theft prevention of the garage. 24-hour lighting not only wastes the earth's resources seriously, but also causes frequent failures of the whole lighting system and greatly increases the maintenance cost. Labor costs are increasing. Three underground garages with 2000 lights need an electrician to maintain, which increases the management cost and electricity bill.

The management of ever-burning lamps should be considered in the conventional energy-saving technical scheme of underground garage lighting system. To this end, many professionals have put forward many schemes to reduce maintenance and replacement.

For example, double rows of lights are lit alternately, which reduces the lighting time to protect the life of the lights and reduce the manual maintenance cost. But this problem still can't solve the most essential problem of huge waste of power resources caused by 24-hour lighting.

It has also been suggested that the way to use PLC control and time relay is to turn on the lights in different periods, that is, turn on the lights during the day and at midnight (6:00-24:00) and turn off half the lights at midnight (24:00-6:00). Because the time is too short, the energy-saving effect of this method is very limited, and it is not suitable for the lighting transformation of underground garage.

The LED intelligent induction garage lamp independently developed by Shenzhen Liqin Zhenghe Technology Co., Ltd., after five years of research and development, perfectly solved the contradiction between continuous lighting and power saving in underground garage lighting, and the energy saving efficiency was as high as 90%!

2.LED intelligent garage lamp is used for lighting renovation of underground garage;

Intelligent induction garage lamp products perfectly combine military radar induction technology with the fourth-generation light source LED lamp to complete a unique new energy-saving lamp, which is called "the king of environmental protection and electricity saving" in the industry.

Two microwave induction schemes for led radar;

1. Slightly bright-fully bright-slightly bright: the LED lamp works weakly (3W). When the microwave radar senses a person or a vehicle, the lamp tube will remain fully bright (12W), and will automatically switch to slightly bright (3W) after 30 seconds, and work with low power consumption.

2. No light-full light-no light: the LED tube is turned off normally. When the microwave radar senses people or vehicles, the lamp will remain in the on (12W) mode, and will automatically switch to the off and off states after 30 seconds.