What should I pay attention to when installing floor heating?

1, the ground is flat and the bathroom and kitchen are waterproof.

2, pipeline design should be reasonable, if the wall-hung boiler heating, each loop should not exceed 80 meters.

3, the ground insulation layer, reflective layer to do well, reduce heat loss.

4. The location of the water separator is chosen for the convenience of future operation and maintenance.

5. After the installation, install the pressure gauge, immediately suppress the pressure to 0.6MPa, and observe for 24 hours. If the pressure does not drop to zero, the pipeline is in good condition.

6, fill the pressure to 0.6MPa, don't relieve the pressure, backfill the cement pisolite layer with pressure, and the proportion of cement, sand, pisolite and water should be appropriate.

7. Waterproof the bathroom and kitchen after backfilling. Observe the pressure and don't drop to zero.

8, after the floor heating project, can't slot on the ground, drilling, nailing, to prevent damage to the pipeline.