How do the small stones on the flowerpot stick together?

Stick the broken stone heads together and the flowerpot will be beautiful.

1 First of all, we have to go outside to collect some stones. The rough surface is better, and it will be firmer when fixed with glue.

2. Then wash and dry the picked stones, prepare several cans, remove the top of the cans, and use an awl to make several holes in the bottom of the cans as drainage holes.

3. Stick the stone on the can with a hot melt adhesive gun. If there is no equipment, you can buy a hot melt adhesive of 20 cents like a flower and stick it with a lighter.

4. If you are worried that the hot melt adhesive will not stick firmly, or you want to stick a big stone, it is best to stick it with nail-free glue, so that the stability of the stone basin will be better.

After all the stones are glued according to the natural size, we can fill the jar with soil and dig some wild green plants to plant.

6. If you are leaning against the mountain, you can dig back some moss and make a pavement for the plants to make the stone flowerpot look more primitive.

7. After planting, it should be placed in a place with astigmatism, and then slowly potted for normal maintenance. If you don't want to plant flowers, you can also pick two branches and insert pine cones to make creative ornaments.

Gravel head+cement, which is stronger to use?

1, prepare a number of broken stone heads (used to pick up thin ones) and a disposable takeaway box, mix cement and sand in equal proportion, add water and stir into a paste for later use.

2. Then stick the stones on the wall of the plastic box and seal the gaps between the stones with cement connection.

3. Cover all the stones to ensure that the stones at the top are on the same plane. Finally, coat the bottom of the plastic box with cement, and remember to dig a hole in the middle to drain water.

4. When the cement is completely dried, the stone basin will be taken out of the mold.

We got the semi-finished products as shown in the figure below.

6. In order to make the flowerpot more firm, cement can be used to re-joint the outside of the flowerpot, and the finished flowerpot should be soaked in vinegar for 3 days before use to remove alkalinity.

Finally, we can fill the finished stone basin with soil and plants.

Stone flowerpots can only be made with tools.

In addition to the broken stone head above, there is also a flowerpot made entirely of stone, but this flowerpot must be made with professional tools and it is very dangerous.

1. Choose a relatively flat stone, install a 3cm hollow drill on the electric drill, and drill several cross circles on the stone, which will be continuously cooled with water.

Knock off a little bit of the stone in the middle with a hammer and chisel.

3. Then press the internal expansion wheel with an angle grinder to smooth the inner wall of the stone basin.