How to restore the factory settings of Rayco nw736 wireless router?

Steps and methods to restore the factory settings of the wireless router nw736: \x0d\ 1. Turn off the power \x0d\ 2. Find a small hole behind the router \x0d\ 3. Press the toothpick into this small hole for 5 seconds under the power-on state to restore the factory state. \ x0d \ x0d \ Regarding the installation and setting of the router, it needs to be configured in the following three aspects: \x0d\ 1, router installation; \x0d\ 2。 Set the computer IP; \x0d\ 3。 Set the parameters of NW736 router. \x0d\ \x0d\ Step 1: Install the router \x0d\ 1. Telephone line Internet users: Please prepare two short network cables, one of which is used to connect the network cable interface on ADSL Modem or optical cat with the WAN interface on Reko NW736 router; One end of the other network cable is connected to the computer, and the other end is connected to any interface of 1/2/3/4 on the RKO NW736 router. \x0d\\x0d\ 2。 Users who use optical cable to surf the Internet: Users need to prepare two network cables, one for connecting the WAN interface between Guangmao and Rayco NW736 router, and the other for connecting the computer and the LAN interface of Rayco NW736 router (1/2/3/4 can be any one). \x0d\\x0d\ 3。 Home network cable: Please prepare 1 shorter network cable. Network cable to the home: refers to the broadband operator providing a network cable to the user's home; Please plug the network cable provided by the broadband operator into the WAN interface of the RKO NW736 router. Then connect one end of the prepared network cable to the computer, and the other end to any interface of 1/2/3/4 on the router of Rayco NW736. \x0d\\x0d\ Step 2: Set the computer IP\x0d\ The wireless router of Rayco NW736 has enabled the DHCP server when it leaves the factory, and can assign IP addresses to the computer, so the computer can obtain the correct IP address information from the DHCP server of the NW736 router only by configuring the computer's IP address automatic acquisition (dynamic IP), and then can configure the NW736 router accordingly; For the configuration method, please read: Configuration method of computer dynamic IP address. \x0d\\x0d\ Step 3: Set up the NW736 router \x0d\ 1. Login management interface: enter: 192. 168. 1 press enter-> and enter the account guest and password guest- > in the jumped page. Click "OK". \x0d\\x0d\ 2。 Configure the Internet parameters: click "Network Configuration"-> "External Network Settings"-> "WAN Settings" in the left navigation menu and select "PPPoE Subscriber (ADSL)"->. Fill in the "PPPoE account" and "PPPoE password"-> click "MAC address cloning" (only select this option when the ISP broadband operator binds the MAC address)-> click "Save to take effect". \x0d\\x0d\ 3。 Wireless network configuration: click item 5 "Wireless Management"-> "Wireless Basic Settings"-> in the navigation bar; The default value of "SSID number" (i.e. wireless name) is "Netcore", please modify it yourself (note: SSID number cannot be in Chinese), and keep the other options as default values-> click "Save to take effect". \x0d\\x0d\ 4。 Wireless security settings: click Wireless Management-> Wireless Security Management-> in the navigation menu; "wpa2 _ PSK" is generally selected as "safe mode" in the right interface->; Then enter the wireless password you want to set in the "Key" box (the password cannot be a special character)-> click "Save to take effect".