Quickly understand the matters needing attention in the construction process of wall fan ash

The construction technology of wall fan ash consumers prefer wallpaper because of its diversified color patterns, good waterproof and moderate price. But if we talk about the process of wallpaper project, I think many friends don't understand it. So, what is the process of wallpaper project? Let's have a look!

1, wallpaper engineering process? -? Scraper putty

Before plastering putty, the surface of the base should be smooth. If there are floating floors and spots on the wall, you can clean them with a steel brush or other tools. Generally speaking, the wall putty can be scraped twice and brushed several times to get uneven parts. Then sand it with sandpaper.

2. Wallpaper engineering technology? -? primer

After the putty is scraped off, the primer can be used in the construction process of wall fan ash. First, the basement membrane or varnish is coated on the wall with a roller. Use it thinly and evenly. ? After 2 days, the primer can be dried. Spread wallpaper.

3, wallpaper engineering process? -? Draw a vertical line

Don't draw vertical lines until the glue is almost dry. Starting from the corner, it is better to be smaller than the wallpaper 1~2 cm. Then measure the whole horizontal datum line with centering hammer, and finally draw a vertical line along the line and mark it at the corresponding position.

4. wallpaper engineering technology? -? paper cutting

Open the purchased wallpaper and check the pattern of the wallpaper. After the direction is determined to be upward, use the floor tile of the bottom plate as the starting point of measurement. After measuring the size, put the wallpaper on the table with the glue face up and the pattern down, and then mark the back of the wallpaper with a pencil. Then cut the thread with scissors. It is best to add corresponding numbers to the cut pattern to avoid confusion when pasting. It is best to leave a margin of 30~50 mm at both ends of the wallpaper.

5, wallpaper engineering process? -? Boring water

In the construction process of wall fan ash, perceptual water is an essential part to paste ordinary plastic wallpaper. It is suggested to wet the back of wallpaper with pen and water first, or roll up the cut background paper.

Wash it in the bucket for 3 to 5 minutes, and then take it out to dry.

6, wallpaper engineering process? -? Glue solidification

When mixing glue, you must adjust it according to the instructions. Under normal circumstances, a certain amount of cold water is put into the bucket first, and then the glue powder of wallpaper is slowly added. Heat is evenly distributed in the same direction, and caking will not often occur. Let it stand for 20 minutes before use.

7, wallpaper engineering process? -? Hang wallpaper

Finally, in the construction process of wall fan ash, wallpaper can be pasted in a specific order, and then slide in the same direction with a special press roller. Bubbles in the wallpaper are ejected, and the pressure is controlled when pressed. It can't be too strong, or the cement slurry will squeeze from the edge of the tape to the surface of the wallpaper, and the wallpaper will be cut.

Conclusion: the construction technology of the above wall fan ash is related to the wallpaper engineering technology. You can explain it, hoping to help those friends in need. If you still need to better understand the content related to the transition period, you should be interested in this information. The above refer to seven skills in wallpaper construction to help you build a temperamental home. I hope these introductions can help you.

Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~