How to stick PVC wood grain stickers on wooden doors at home?

First, prepare tools: the surfaces of scissors, rags and art knives must be cleaned and leveled. This directly affects the effect and quality after pasting.

Two. Measure the width and length of the pasted object, and cut out the specifications slightly larger than the pasted object. Because this material is not easy to tear off after pasting, so as not to find that one side is not enough to cover the pasted object after pasting. The extra parts can be folded or planted after being pasted.

Three. Tear a parallel backing paper first.

Four. Aim at the object to be pasted, and ensure that it can be covered by wave film all around. If you paste the wall, you should make a vertical line.

Five. Wipe hard with a wet cloth to ensure that the air is driven out and avoid bubbles.

Six. First of all, you need to find someone to help you, while slowly pulling the back paper parallel, while slowly wiping the air back and forth with a cloth. This step is very important and directly affects the effect and success or failure. So you must tear it slowly, bit by bit. If you find bubbles that dare not come out, you can tear them back and drive the air out. However, it should be noted that it may not be possible to return, and it can be gently heated with a hair dryer. Do not tear the sticker forcibly, otherwise it will damage the sticker. Excess parts can be planted or folded with cloth. If there are blisters after pasting, you can punch a hole with a needle and then use a cloth to drive away the air.