How does the automatic water mill cut by itself?

When operating the lathe manually, it is necessary to confirm the current position of the cutter and workpiece, and ensure that the motion axis, direction and feed speed are specified correctly. When the handwheel is fed, rotate the handwheel with a larger magnification, and the cutter and workbench will move quickly, which may cause the handwheel to stop rotating, but the cutter and workbench will not stop immediately. Always check whether the lubricating oil is sufficient, whether the pipeline is blocked, and whether the lubricating oil and coolant are dirty and need to be replaced.

Whether the tool rest rotates smoothly, whether there is interference in tool installation and disassembly, and whether the tool tip is damaged; Whether there is dirt in the cone hole of the tailstock of large water mill and whether the cone surface is damaged. Regularly check whether the two-axis movement is smooth, and regularly clean the travel switch to avoid the influence of oil, water and dust. Wipe the appearance of lathe regularly, such as operation panel and system display; Regularly check whether there is dust in the electrical cabinet and the entrance and exit of the electrical cabinet, and wipe it clean if there is dust.