Work requirements of automobile stamping die design department

According to your situation, it is estimated that it will be the structural design of the mold, and the requirements are not high.

1, there will be a series of training for newcomers, including software operation, design standards, design ideas and methods. If possible, there will be old employees to show you, and then there will be practical exercises. This kind of training will last for one or two months, and you can basically work.

2. Don't worry about the software. UG is a very powerful software, but there are only a dozen commands for mold design. After repeated use, I can get started in three days. As an old employee, I have no special software skills and operations.

I thought design was a magical profession like you, but in fact, at best, it was a draftsman. .................