Matters needing attention of remote control lamp holder

1. The remote control switch is installed for the first time, and it takes about 20 seconds for the switch to work normally after the power is turned on. 2. It is normal that the shell has thermal sensation when the switch works. It is recommended not to overload, otherwise the service life of the switch will be shortened. 3. If the switch is only connected to the load of an inductive fluorescent lamp, if it doesn't work normally, please change it to a qualified and genuine upconverter, such as Foshan Lighting or Jiufo Electric. The real up-converter has a built-in spark suppression capacitor, which has a long service life. You can also put the built-in selector switch at the sign of "induction fluorescent lamp". Or remove the upconverter of the original lamp and connect a resistor of 200K-270K/0.25W between the two legs of the bubble. 4. When using the remote control, please pull out the remote control rod antenna, which can increase the remote control operation distance and make the operation more reliable when it is always closed. 5. If it is found that the distance of the remote controller is getting closer and closer and the indicator light becomes dim during the use of the remote controller, please replace the battery of the remote controller in time. 6. The first power-on switch (including power failure and incoming call) is in the reset off state.