What are the causes of problems with the spool of steam solenoid valve?

Installation errors, such as wrong installation direction and wrong wiring, will cause the solenoid valve to fail to work normally, which will seriously lead to the damage of solenoid valve components, such as the damage of solenoid valve core or other interfaces.

Reason 2: The working environment has changed.

For example, if the temperature and pressure of the working environment or the nature of the medium change, the user still reluctantly uses it, or continues to use it without knowing it, which may easily lead to the failure of the solenoid valve core.

The third reason is the problem of model selection

If the user chooses the wrong solenoid valve model, it will cause the failure of the solenoid valve, such as overload condition, which will easily lead to the damage of the solenoid valve parts.

The fourth reason is the nature of the media.

If the attribute of the medium is not within the scope of application of the solenoid valve, it may also cause the spool to fail to work. When using the solenoid valve, read the instructions carefully to prevent the medium from being out of the scope of application.

The fifth reason is the problem of foreign body blockage.

Check whether the solenoid valve core is blocked by sundries. The general blocking position is at the end of the pipeline and around the valve core. The solution is to disassemble the solenoid valve, check and clean up these easily blocked positions.

Reason six. The spool has been damaged.

If the solenoid valve is damaged for a long time, in this case, a new solenoid valve needs to be replaced directly. Or the gap between the actual working environment and the applicable range of the solenoid valve is too large. Cause the solenoid valve to affect the valve core or damage the solenoid valve core when working.

Reason seven, improper operation

For example, when using a normally closed solenoid valve, it is normally open, and the power supply pressure and working environment are inconsistent with the half range of the solenoid valve itself.