How to install Xiaomi driving recorder?

The installation of Xiaomi driving recorder includes the following steps:

First, determine the best installation location of the driving recorder. It is recommended to install it on the right side of the rearview mirror in the car, as far as possible in the middle, so that the shooting angle will be corrected and more valuable.

Second, according to the length of the power cord to determine the best wiring scheme, it is recommended to simulate wiring to determine whether the power cord is long enough.

Thirdly, after determining the installation position and wiring scheme of the driving recorder, insert the power cord of the recorder into the gap of the roof.

Fourth, after the roof line is inserted, it is necessary to pull down the door frame sealing strip, and then open the A-pillar decorative panel with both hands. Most of the A-pillar decorative panels are fixed with buckles, which will be tight for the first time. Don't be afraid to use some power.

5. The purpose of removing the A-pillar decorative plate is not to put the wire in the A-pillar, because many models have side air curtains, which may affect safety. Just let the power cord pass through smoothly, then insert the cord into the door frame sealing strip, aim at the A-pillar buckle, and gently knock the A-pillar decorative plate in with your fist.

6. Install the sealing strip from the upper end of the A-pillar along the door frame, and insert the power cord into the sealing strip until the wire is thrown out at the bottom of the instrument panel.

Seven, the power cord through the back of the glove box, according to the actual situation of different models, the line can be fixed behind the glove box, can also be hidden under the firewall or rubber.

Eight, in order not to see Tai how bright line near the cigarette lighter, it is necessary to loosen the decorative plate screw at the bottom of the center console, open a small gap, insert the line into the gap and then tighten the screw, but many models need to be flexible.

9. Plug in the cigarette lighter, and after confirming that the driving recorder can be powered on normally, the installation and wiring are completed.