Huaihua Jingzhou pig raising equipment pig cement manure leakage board

Hello, Nong Lesheng's cement manure leakage board mold is completely produced with imported raw materials. Compared with the manure leakage board mold produced by secondary composite materials on the market, it has the advantages of reasonable design and long service life. Reasonable use can make the number of uses reach more than 1000 times, greatly improving the service life and saving the production cost. It is the first choice brand for large pig farms and breeding equipment factories. The mould size of cement bushing is 60 * 80cm 60 *110cm 60 *105cm 60 *165438.

Advantages of using Nongshengle cement manure leakage board mould;

1. High strength: corrosion resistance and wear resistance. A mold can make 3000 pieces of manure leakage boards, and the mold is made of high-quality polypropylene plastic by one-time injection molding.

2. Save water: the design of empty manure leakage space is reasonable, the manure leakage effect is excellent, and water is basically not used for flushing, saving manpower and funds, and more importantly, reducing the workload of treating manure and sewage.

3. Beneficial effects: The pigsty built with the cement manure leakage board can effectively control the temperature, humidity and harmful gases in the pigsty. The temperature is high in summer, and the hot temperature will cause serious thermal stress to pigs, which will affect the growth rate and even lead to illness and death. If the pig bed equipment built by manure leakage board is used, the wind energy will be cooled from top to bottom in summer, which will solve the economic loss of pigs eating less and growing longer in summer.

How to use the cement bushing mold;

After preparation, cement, sand and stones are mixed evenly according to the ratio of 1: 1: 2: 2, and then the mold can be installed. Before filling, apply waste engine oil or hydrated lime in the mold groove to facilitate demoulding in the later stage. When pouring the mold, concrete material is injected into the mold from above. During the injection process, the periphery of the mold is hammered to make it tight and firm. The demoulding time is 12- 16 hours in summer and 24-28 hours in winter. If the product has some burrs and bumps, it can be slightly polished with sandpaper when the product is not fully formed.