Xi'an OPPEIN gas stove after-sales service phone official repair point

Xi'an Oppein gas stove repair 400-------6818-----?---869----Service area Beilin District High-tech Zone Weiyang District Lianhu District Yanta District Ba Bridge area.........

Manufacturer repair ignition stove common faults and troubleshooting methods:

Pay attention to the correct installation position.

1. Out of flame or out of flame

a. The damper is too small, adjust the damper; b. The nozzle is too small, expand the nozzle; c. There is air mixed in the gas pipeline, repeat Ignition action, exhaust the air; d. The pressure in front of the stove is too high, the opening of the main valve can be appropriately adjusted. For liquefied gas, professionals should be asked to adjust or repair the pressure regulator (the outlet pressure is too high).

2. Tempering

a. Strong wind blows the flame, and avoids strong wind blowing directly to the flame; b. The air pressure is too low, increase the opening of the valve and ask the gas supply department if it has stopped. air; c. Seal combustion and provide appropriate air volume; d. The damper is too large, close the damper; e. The design is unreasonable, the diameter of the fire hole is too large, the space is too large, etc.; f. The nozzle is too small or blocked, replace it Remove the debris from the nozzle or use a needle to clean it; g. The fire cover is not in place, adjust the installation position; h. The fire cover and burner are aging, replace the fire cover and burner.

3. Black smoke or yellow flame

a. The damper is fully closed and the damper is opened appropriately; b. There are spider webs in the ejector tube, remove the spider webs; c. The model of the stove Wrong selection, artificial gas is used as a liquefied gas stove; d. The fire hole of the ignition ring is blocked, clean the fire hole of the ignition ring; e. There is foreign matter in the nozzle hole of the stove, clean the foreign matter.

4. Air leakage or gas odor

a. The hose is broken or not connected properly, replace it with a new hose and fix it; b. The seal at the valve joint is aging, replace the sealing ring; c . If the valve fails for a long time, replace it with a new valve; d. The burner does not ignite, troubleshoot and re-ignite; e. If there is misfire or flame separation, clear the misfire (solve it according to the previous method); f. The universal joint is leaking. Repair or replace the universal joint; g. If the welding is not strong and there are blisters, replace or re-weld the tee; h. The nozzle is not inserted into the ejector pipe, reinstall the nozzle; i. Cylinder, angle valve or pressure regulator, Replace cylinder or regulator.

V. Other phenomena

1. There is an open flame. a. The assembly is stuck and will not recover. Replace the assembly; b. The valve core spring falls off. Repair or replace the assembly; c. , Assembly accuracy is poor, reassemble.

This answer was recommended by the questioner