What are the requirements for wooden door installation? What is the installation sequence of wooden doors?

Wooden doors are very common in home decoration. Many people like to install wooden doors at home, but a good wooden door, the construction technology is very important, wooden door installation is a technical activity, can not be careless, but now wooden doors are getting less and less fine. The following is the wooden door installation steps and woodworking installation process to show you what to pay attention to.

First, the wooden door installation process

1, wooden door installation introduction

(1) Wooden doors must be installed with reserved holes. It is forbidden to install them while laying bricks or stones.

(2) Wooden doors can only be installed after the ground works (such as floor tiles and stone materials) of the installation holes are installed, and the wall putty can be leveled and polished (the holes where wall tiles and stone materials are attached to the wall must be completely attached to the hole edge).

(3) When the humidity of the installation hole wall is 25%, a moisture-proof isolation layer should be made on the installation hole wall.

(4) The wooden door installation site environment is clean and tidy, without sundries and crossover operation.

2. Wooden door installation tools: electric hammer, woodworking hammer, planer, flat file, fine-tooth saw (hacksaw), screwdriver, square ruler, tape measure, hanging hammer, spirit level, electric drill, hole opener, punch and drill bit with corresponding specifications.

3. Wooden door installation materials: iron piece connectors, 60 nails, 25 and 20 self-tapping screws, 502 glue, towels or cotton yarn, sawdust, small wooden strips, pig brushes, styrofoam, white latex, door locks, hinges, door suction, and moisture-proof wall materials.

Second, the wooden door installation steps

1. Assemble door cover.

When installing the wooden door, first find out the door cover and riser, and align the seams according to the number on the back. Joints should be on the same plane, and the joints should be coated with glue.

2. Install the door cover.

Put the firmly assembled door cover into the doorway, and fix the door cover around with small wooden strips. Both sides of the door cover should be on the same plane as the wall. Then check whether the door cover is vertical to the ground, whether the two corners of the top plate of the door cover are at right angles to the two vertical plates, whether the vertical plates of the door cover are bent, and wind the iron plates at both ends on the wall.

3. Install the door leaf.

Open the hinge slot first, and the distance between the hinge slot and both ends of the door leaf should be110 of the height of the door leaf.

4. Install the door lock.

After installation, check whether the door leaf and door lock switch are flexible, whether the joints are flexible and whether the joints meet the specifications.

5. Install the door cover wire.

Cut the door cover line with right-angle edge into a 45-degree angle, trim it with a carpenter's plane, insert the right-angle edge into the door cover groove, and stick the door cover line to the door cover with floor glue.

6. The last step of wooden door installation is to install door suction in the corresponding position.

About the introduction of wooden door installation steps, wooden door installation technology is introduced here, hoping to help everyone.