Do you know the advantages of Buji flexible waterproof material?

Flexible waterproof coating is a one-component, pure acrylic emulsion T-999 polymer waterproof coating. It consists of high-quality aggregate, selected additive powder and liquid polymer additive. After the powder is mixed with additives, a chemical reaction takes place to form a tough elastic waterproof film, which has good adhesion to concrete and mortar, and can form a close and firm permanent combination with it to prevent water infiltration. Its characteristics are: 1, which is flexible and can adapt to slight vibration and certain displacement of building structures; 2, good adhesion, not only good adhesion to the base surface, but also direct adhesion of ceramic tiles to the waterproof membrane; 3. It can be constructed in humid environment; 4. It has good air permeability, excellent aging resistance and good corrosion resistance; 5, non-toxic and harmless, belonging to a new generation of environmental protection products. Scope of application: 1, around various pipelines, expansion joints, structural cracks, cement fiberboard, joints of metal plates, etc. 2, building roof, balcony, basement, bathroom, sink, swimming pool, subway, tunnel and other waterproof projects. Base surface treatment: 1, and the surface must be smooth, solid, clean and free of loose animals such as oil stain and dust; 2, obvious cracks and sand holes must be blocked with cement mortar, smooth, sharp edges and corners should be eliminated; 3. Prewetting the substrate until there is no accumulated water; 4, the new concrete should have a certain curing time, in order to prevent the influence of concrete shrinkage; 5. The old concrete surface must be washed with clear water first, and then painted after drying. Construction technology: 1. Open the lid and use it; 2. Brush the mucilage directly on the base surface with a brush or roller brush, and do not miss the brush. 3. After one layer is finished, you must wait until it is slightly dry (just stick) before applying the second layer, which usually takes 1-3 hours, depending on the density and temperature of the substrate. If the coating has been cured for more than 24 hours, it must be wetted with clear water first; 4. Generally, the coating is brushed for more than two times (the brushing direction should be staggered each time), and the final coating thickness is kept at 1.2~ 1.4mm, and the dosage is about1~1.5; 5. At the same time of painting, corner joints and cracks should be reinforced with non-woven fabrics or glass fibers to enhance crack resistance and tensile properties. When the waterproof membrane is directly attached to the ceramic tile, it must be painted on the surface, so that the waterproof membrane completely covers the substrate to achieve waterproof effect.