How is the stamping die installed?

1. Purpose: To ensure the correct installation of the mold. 2. Scope of application: it is suitable for the die adjusters of the stamping die of our company. 3. Responsibility: The mold adjusters put this work instruction into practice. 4. Work Procedure 4. 1 According to the production plan, determine the type and identification of the mold to be used. 4.2 Be familiar with the stamping process specification of the debugged parts and the requirements of each process. 4.3 Check whether the dimension parameters of the mould to be installed can meet the equipment specifications specified in the process. 4.4 Check the mold used, and master the structural characteristics and operation methods of the mold, as well as matters needing attention. 4.5 Select the machine tool according to the process specification, and check whether each part works normally. If you need to check the parallelism of the machine tool, inform the mechanic. 4.6 Before installing the mold, clean the upper and lower surfaces of the machine, slider and mold. 4.7 The shim required for adjusting the height of the mold and the height of the machine tool can only be placed under the lower template of the mold; If it is really necessary to pad on the upper formwork, it should be carried out under the guidance of the mold repairer. 4.8 The die pad iron must be higher than the compression part of the die, and the diagonal locking method is gradually adopted. 4.8 When adjusting the mold, put the change-over switch in the inching position. 4.9 After the mold is installed, turn the travel switch to the "Adjust" position and gradually adjust the travel depth. 4. After the10 mold is adjusted, start the switch for trial stamping. 4. 1 1 In the production process of stamping die, after the first trial stamping is qualified, explain the matters needing attention in normal production to the operator.