How to equip 160cm air-jet loom with a car stopper?

One shift must be clear, two investigations and three questions.

A clear: do a good job of machine hygiene before taking over. Specific requirements, 1 should clean the machines under its care and the sanitation around them every day. 2 Do a good job of winding the flannel stick and the machine barb stick. 3 cleaning method: gently shake and wipe, don't beat the air duct to prevent the flying flowers from polluting the grey cloth. 4 cleaning sequence: from top to bottom, from inside to outside. Align hand and eye, and clean and inspect the machine at the same time. Be safe. Second inspection: 1 Check the cloth carefully before taking over. A requires all machines responsible for him to be inspected once to prevent continuous defects. B. Carefully check the cloth surface by hand-eye combination, and feel the tension of the cloth surface, whether there are continuous defects and whether there are abnormal noises in the ears. Patrol the front desk machine and rear axle after taking over, and ask to patrol all the machines under your care. Straighten out a lot of heads, borrow heads, twist heads, etc. Three questions: 1 Ask about variety change and weft replacement. 2 ask about mechanical operation. 3 ask about the production situation. Such as broken cars, continuous defects and so on. The second boot must be done with one look, two calls and three boots.

Look: See if anyone is working. Two phones: when two or more people operate, they must greet each other before turning on the phone. Three boot: the interlock switch is left-handed, and the other switches are right-handed, so you must use both hands to boot. Three. operation requirement

1 After stopping weft, you must pull two weft yarns, and check the reasons before starting the machine. The drawn weft yarn should be put into the waste bobbin. 2. Before starting the machine, hold down the thin product by hand while supporting the front weaving shed to prevent the edge from being blocked.

3 To deal with all kinds of stop losses, we should follow the principle of easy before difficult, far before near, and adopt flexible methods. 4. Check whether the weft of the machine is accurate. When checking the cloth, keep your eyes and hands in a line, and touch them with your eyes, so that you can patrol from hand to eye continuously.

If you find broken heads and bulls during the tour, you must return them. If the weft or paper tube is different in color and the machine is abnormal, the relevant personnel should be informed immediately.

6 Stop the machine and clean the reed before laying cloth, lay cloth on the reed and embroider the words such as car number, shift and date. Four drops operation:

1 When dropping cloth, lock the left and right ends of the grey cloth with a needle, then pull out the locating pin of the cloth stick, then pull away the fixed handle of the cloth stick, and finally pry the grey cloth out of the waste yarn barrel with a special laying tool. It depends on whether there are people around. Be safe.

2 When hanging the cloth stick, first insert the special tool into the machine, then put on the empty cloth stick, then lock the handle of the cloth stick, roll up the cloth, and finally pull out the special tool and put it away.