How to set the taper of wire cutting veneer computer is better than cutting a 5MM circle taper, Ningbo veneer, the more detailed, the better.

First set the height, shift+Height +x+ Enter the first parameter (the distance between the upper guide wheel and the lower guide wheel) +x+ From the lower guide wheel to the bottom of the workpiece +x+ Guide wheel radius +x, and the minimum arc below is 0+ standby +shift+angle+degree+standby+computer programming+standby+Shift+1+B. If not, then tell me the buttons on the solo plane where you want to set the taper, and I'll tell you what they do in detail. I feel that you have a lot to learn.