How to remove the motor cover of micromotor?

1. Before removing the sliding bearing end cover, drain the grease, lift and fasten the oil ring.

2. Then, for slip-ring or commutator motors, take out the brush or lift it, tie it firmly, and mark the position of the brush grip. During disassembly, be careful not to damage the brush and lifting device.

3. Finally, for the motor with roller bearing at the load end, the non-load end should be removed first. To remove the end cover on the fan side, first remove the screws on the end cover, and then pull out the rotor, end cover, bearing cover and fan together. It's over.